John Lewis JLBIDOS904 - Manual (Page 5)

5
Installation
The oven must be installed according to the
instructions supplied.
Technical Data
Voltage: 230-240 Volts AC 50Hz
Wattage: 5.0-5.5kW
Height: 897 mm
Width: 592 mm
Depth: 563 mm
(excluding handles and knobs)
Weight: 55kg
THIS OVEN MUST BE EARTHED
Electrical Requirements
This appliance must be installed by a qualified
electrician/competent person. Safety may be
impaired if installation is not carried out in
accordance with these instructions.
Do not remove the screws from the earth tab
extending from the oven mains terminal block (Fig.
1).
Before connecting the appliance make sure that the
voltage of your electricity supply is the same as that
indicated on the rating plate. This is situated on the
lower front frame of the appliance and can be seen
upon opening the door. Alternatively the rating
plate may also be found on the back or top of some
models (where applicable).
Do not alter the electrical circuitry of this appliance.
Electrical Connection
•
There are three possible ways to connect your
appliance. In each case the appliance should be
operated using at least 6mm 2 twin core and
earth PVC insulated. Please choose from the
most appropriate after reading the different
methods:-
a) By connecting the appliance to a cooker point
(having a double pole isolating switch with at
least 3mm contact separation in all poles and
neutral) and protected with a fuse or miniature
circuit breaker at your mains fuse box.
Subject to Regional Electricity Companies
regulations, if you wish to connect the
oven and hob to the power supply you
may use one of the following two
methods:-
This appliance complies with:
European Council Directive
73/23/EEC.
EMC Directive 89/336/EEC.
CE Marking Directive 93/68/EEC.
Energy Label Directive
2002/40/EC.
Electrical Connection
Fig.1