John Lewis JLBIDOS904 - Manual (Page 6)

6
b) By connecting the appliance together with a hob
directly to a cooker point(s). Having a double
pole isolating switch with at least 3mm contact
separation in all poles and neutral.
c) If you wish to connect an oven and a hob to a
cooker point you can by connecting the oven
and hob separately to the cooker point. Oven
and hob units should be separately connected to
a cooker point. See Fig. 2.
NOTE: It is good practice to :
•
Fit an Earth Leakage Circuit Breaker to your
house wiring.
•
Wire your appliance to the latest IEE regulations.
Things to Note
•
This appliance is designed to be fitted in cabinets
of the recommended dimensions as shown
(Fig.3).
•
If your cabinet interior dimension is between
565-570mm the oven may still be fitted.
However, a minor modification to the cabinet
will be required to reduce the aperture size
down to 560-565 mm, to allow the product to
be securely screwed into the cabinet.
•
The dimensions given provide adequate air
circulation around the unit within the cabinet,
ensuring compliance with BS EN60-335.
•
Enquiries regarding the installation of the cooker
point, if required, should be made to your
Regional Electricity Company to ensure
compliance with their regulations.
•
The appliance socket switch should be outside
the cabinet but within 2m of the appliance to
make it accessible to switch off the appliance in
case of an emergency.
•
To protect the hands, wear gloves when lifting
the oven into its housing.
Do not lift the appliance by the handles.
Note: House Circuit
Earth leakage and continuity tests must be carried
out before the appliance is connected to the mains
supply and re-checked after fitting.
Connection
via Min. size
Cable/flex Cable/flex
type Fuse
• Cooker
Control
Circuit
6mm 2 PVC/PVC
twin and
earth 35 A
(min)
Preparing Cabinet for Fitting
of Oven
•
Make sure that the cabinet is the correct size for
the appliance to be fitted (Ref. Fig. 3).
•
If the size is between 565-570mm, then the
cabinet should be modified so that at the screw
fixing points the recommended dimension of at
least 560-565mm is maintained. The modification
should ideally be localised to ensure that after
screw fitment the oven is securely fixed into
position.
•
The cabinet must be stable and level by firmly
securing it to the wall or floor. If necessary,
make arrangements to ensure the shelf upon
which the oven will rest is level.
•
When the appliance is installed ensure a
minimum gap of 2mm is maintained between the
trim on the bottom edge of the appliance, and
any corresponding door / panel underneath.
Fig. 2