John Deere CD4039DF008 - Manual (Page 31)

Safety
DX,PAINT –19–03MAR93–1/1
REMOVE PAINT BEFORE WELDING OR
HEATING
TS220
–UN–23AUG88
Avoid potentially toxic fumes and dust.
Hazardous fumes can be generated when paint is heated
by welding, soldering, or using a torch.
Do all work outside or in a well ventilated area. Dispose of
paint and solvent properly.
Remove paint before welding or heating:
•
If you sand or grind paint, avoid breathing the dust.
Wear an approved respirator.
•
If you use solvent or paint stripper, remove stripper with
soap and water before welding. Remove solvent or
paint stripper containers and other flammable material
from area. Allow fumes to disperse at least 15 minutes
before welding or heating.
DX,RCAP –19–04JUN90–1/1
SERVICE COOLING SYSTEM SAFELY
TS281
–UN–23AUG88
Explosive release of fluids from pressurized cooling
system can cause serious burns.
Shut off engine. Only remove filler cap when cool enough
to touch with bare hands. Slowly loosen cap to first stop
to relieve pressure before removing completely.
05-9
112699
PN=31