Others – JVC TK-C655 User Manual
Page 42
![background image](/manuals/133053/42/background.png)
42
Others
Attaching a Ceiling Flush Mount Bracket (Optional WB-S575)
The ceiling flush mount bracket (optional WB-S575) allows the camera to be installed flush with the ceiling surface. In this case the
ceiling material should have a thickness of between 5 mm and 31 mm.
1.
Make a hole (diameter 200 mm) in the ceiling.
If anchor bolts can be used, attach them using M8 - M10 (or 3/8 inch)
nuts.
CAUTION
• Make sure that the clamping brackets grip the ceiling plate firmly.
• If the ceiling flush mount bracket rattles after the clamping screws
are tightened, loosen them fully and tighten them again.
Mount hole
Anchor bolt mount holes
Clamping
screw
Mount screws (x 4)
Clamping screw
Clamping
bracket
3 positions
Clamping
screw
Diameter 200 mm
Loosen
Stoppers
Anchor bolt mount
Clamping screw
2.
Prepare the Ceiling Flush Mount Bracket.
• Fully loosen the clamping screws (by turning them counterclock-
wise).
• Move the clamping brackets toward the inside as shown in the
diagram.
• Remove the four mount screws.
3.
Clamp the Ceiling Flush Mount Bracket.
(1) Fit the Ceiling Flush Mount Bracket into the hole in the ceiling.
(2) Ensure that the stoppers are pressing against the back of the
ceiling plate.
(3) Push the Ceiling Flush Mount Bracket all the way up and tight-
en the three clamping screws (by turning them clockwise).
(1)
(2)
(3)