John Lewis JLBIDW 1201 - Manual (Page 17)

Fill with detergent
30
20
1. Press the release button (3) to open the
lid (4) of the detergent dispenser.
2. Put the detergent in compartment (2).
3. If the washing programme has a prewash
phase, put a small quantity of detergent
in compartment (1).
4. If you use detergent tablets, put the
tablet in compartment (2).
5. Close the lid. Make sure that it locks into
position.
Detergent tablets from different
manufacturers dissolve at different
rates. For this reason, some
detergent tablets do not attain their
full cleaning power during short
washing programmes. Therefore,
please use long washing programmes
when using detergent tablets, to
ensure the complete removal of
detergent residual.
Using combi detergent
tablets
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and
rinse aid dispenser.
Be sure that these tablets are applicable for
the water hardness in your area (refer to the
instructions on the packaging of the
products).
1. Adjust manually and electronically the
water softener to the lowest level.
2. Set the dosage of rinse aid dispenser to
the lowest position.
Using again separately
detergent, salt and rinse aid
1. Fill the salt container and the rinse aid
dispenser.
2. Adjust manually and electronically the
water softener to the highest level.
3. Start a washing programme without
dishes.
4. When the washing programme is
completed, adjust the water softener to
the water hardness in your area.
5. Adjust the rinse aid dosage.
17