Water connection, Fixing to the adjacent units, Water inlet connection – John Lewis JLBIDW 1201 User Manual
Page 25: Water drain connection
During all operations that involve
accessibility to internal components the
appliance must be unplugged.
Be sure that once the appliance has been
installed, it is easily accessible for the service
engineer in the event that a repair is
required.
Fixing to the adjacent
units
The appliance must be secured against
tilting.
Therefore make sure, that the counter it is
fixed under, is suitably secured to a fixed
structure (e.g. adjacent kitchen unit cabinets,
wall).
Water connection
Water inlet connection
This appliance must be connected to a cold
water supply.
For making the connection itself, the
coupling nut fitted to the appliance inlet hose
is designed to screw onto a 3/4" gas thread
spout or to a purpose made quick-coupling
tap such as the Press-block.
The water pressure must be within the limits
given in the ‘Technical data’. Your local
Water Authority will advise you on the
average mains pressure in your area.
The water inlet hose must not be kinked,
crushed, or entangled when it is being
connected.
The appliance features inlet and drain hoses
which can be turned either to the left or the
right to suit the installation by means of the
locknut. The locknut must be correctly fitted
to avoid water leaks.
If the appliance is connected to new pipes or
pipes which have not been used for a long
time, you should run the water for a few
minutes before connecting the inlet hose.
This appliance has been fitted with safety
features which will prevent the water used in
the appliance from returning back into the
drinking water system. This appliance
complies with the applicable plumbing
regulations.
Caution! Do not use inlet and drain
hoses which have previously been
used on another appliance.
Water drain connection
The end of the drain hose can be connected
in the following ways:
• To the sink outlet spigot, securing it to the
underside of the work surface. This will
prevent waste water from the sink
running into the appliance.
• To a stand pipe provided with venthole,
minimum internal diameter 4 cm.
25