John Deere OMM141979 J9 - Manual (Page 15)

Removing - 11
REMOVING
Lock Frame Wheels Into Engage Position
1. Move to left rear, behind tractor drive wheels—pull and
hold out wheel locking pin (A).
2. Swing left wheel assembly (B) down into “ENGAGE”
position. Make sure locking pin engages hole in locking
bracket. Repeat for right frame wheel.
Disengage Frame Support Rod
1. Move to left side, under tractor footrest—push and hold
lift handle (A) down.
2. Pivot support rod (B) down into storage position.
3. Slowly release downward pressure on lift handle (A).
Remove Tiller From Tractor Rear-Frame
Mounting Hardware
1. Get a helper or use a floor jack with wheels to safely
support and slide tiller housing as you slide frame hooks
(A) from of rear-frame mounting hardware (B).
2. Carefully roll tiller out-from-under rear of tractor.
c
CAUTION: Avoid injury! Maintain a secure grasp
of lift handle (A). Keep hands clear of pinch
areas between tiller and tractor frame.
M96277
A
A
M96279
B
A
M41781
A
M96255
B