Jabra PRO 9460 - Manual (Page 24)

24
en
g
li
sh
Jabra PRO 9460, Jabra PRO 9460 DuO, Jabra PRO 9465 DuO anD Jabra PRO 9470 useR manual
CONNECT TO BASE 3. In the (first)
CONNECT TO
BASE screen,
shown left,
connect the
handset as
shown.
CONNECT TO BASE
4. In the (second)
CONNECT TO
BASE screen,
shown left,
connect the
cable with
the blue
marking to the
base port, as
indicated in
the wizard.
Figure 22: Connect as shown here Figure 23: Connect as shown here
CONNECT DESK PHONE 5. In the
CONNECT
DESK PHONE
screen, shown
left, connect
to the
handset port.
CONNECT
6. In the (second)
CONNECT
screen, shown
left, connect
the control
cable attached
to the gn1000
to the base’s
auX port.
Figure 24: Connect to the handset port Figure 25: Connect control cable to AUX port on the base
GN1000
Mount and configure
GN1000 on desk phone.
Follow the instructions in
GN1000 manual
7. In the (first)
GN1000
screen, shown
left, mount
and configure
the gn1000
on the desk
phone.
GN1000
Did the GN1000 lift the
handset successfully?
Yes No
8. In the (second)
GN1000
screen, shown
left, you must
determine
whether the
desk phone
went off-hook.
If so, touch Yes.
Figure 26: Mount and configure on the desk phone Figure 27: Touch Yes if the handset was lifted
If the handset was not lifted, touch No. In this case, you can choose to Retry or Cancel. If you choose to retry, the
touchscreen takes you back to a point in this flow just after step1 (where Jabra gn1000 has been selected). If you
choose to cancel, the setup is aborted and the touchscreen takes you to the start of the cabling procedure for
configuration without ehs or gn1000. you can return to the gn1000 setup later.