Jabra PRO 9460 - Manual (Page 50)

50
en
g
li
sh
Jabra PRO 9460, Jabra PRO 9460 DuO, Jabra PRO 9465 DuO anD Jabra PRO 9470 useR manual
8.4 PaiRing and connecting the BaSe and headSet
to enable secure wireless communication between the Jabra PRO headset and its base, you must pair the two
units. Once paired, they will find, connect and communicate with each other as needed whenever they are in
range and turned on, but they will ignore all other DeCt devices in the area.
Pairing the DECT Base and Headset
the headset can only be paired with one base at a time, while the base is able to pair with one primary
headset and an optional and temporary secondary headset. the secondary pairing enables you to share your
conversation with another headset user to support conference calling (see the section “Conference Calling”). you
cannot pair the Jabra PRO base or headset with other types of DeCt products.
to pair your base and headset:
1. Dock the headset to the charging cradle of the target base.
2. If the headset is not already paired with that base, then the touchscreen will ask you if you would like to do
one of the following:
- Pri. (Pair as primary): touch this icon to make the current headset the new primary device for the current base.
this will remove any previous primary headset.
- Sec. (Pair as secondary): touch this icon to make a temporary connection to the current headset. this
connection will only last until the end of the next (or current) call. the current primary headset will be kept
and all audio will be shared with both headsets.
- No (Do not pair): touch this icon to charge the current headset without pairing with it.
3. touch the icon of your choice and you are done.
Note: a similar pairing mechanism is also used by Bluetooth® devices. Jabra PRO 9470 supports
Bluetooth® for the purpose of adding a mobile phone to your headset solution. however, the Bluetooth®
pairing is completely independent of the DeCt pairing mechanism described above. see Section 9.2:
Pairing and Connecting with Other Bluetooth® Devices for details.
Once you have paired the base and headset, the base manages the connection automatically even as you take
the headset out of range and/or turn off the devices from time to time. the connection activates itself again
automatically the next time the Jabra PRO Base and headset are turned on and in range.
8.5 call oPtionS Menu
when you are on a call, you can access the Call Options menu by touching the icon in the upper right-hand
corner of the screen, as shown below:
1
1 Mute: enables you
to mute/unmute the
microphone on your
headset. you can also do
this by double-tapping
the touch-panel on the
side of your headset.
Call OPtIOns
speaker
volume
enable Recording
tone setting
Figure 52: Checking your call options
to view/edit the settings available here, touch one of the following options from the Call Options menu: