JVC DYNAPIX LCD IDTV WITH D.I.S.T. LT-32D50BJ - Manual (Page 29)

Operation with the DTV menu
29
LT-32/26D50BJ/SJ / LCT1703-001A-U / ENGLISH
The TV power lamp begins flashing at three
minutes before the timer start time. If you are
watching TV at the time, a message appears
on the screen to inform you the timer is about
to start.
If the TV is in Standby, the power lamp
lights orange while timer recording is in
progress.
• When performing timer recording with a
T-V LINK compatible recording device,
test the timer recording before you record
the programme. There are some T-V
LINK compatible recording device that
will not correctly receive the Direct Rec
command from the TV.
If the recording device does not operate
when the recording start time is reached, it
is not receiving the Direct Rec command
from the TV. In this case, follow the
instructions of “When recording on a T-V
LINK incompatible VCR:”.
While the timer is in operation:
• You can turn the TV on or off (Standby).
WARNING: Do not turn off the main
power.
• You can watch Analogue terrestrial
broadcasting channels or the pictures via
an EXT terminal.
• Please note that any programme
information that appears on the screen,
such as when making changes to the
Digital terrestrial broadcasting (DVB-T)
channel picture, will be superimposed
over the picture in the VCR recording.
• You cannot change Digital terrestrial
broadcasting (DVB-T) channels while
recording.
Cancelling and resetting the timer
setting:
Cancelling the timer setting
Display the TIMER MENU and press the
6
buttons to choose which timer
setting to cancel. Press the 5 buttons
so that “Inactive” appears in the Mode
column.
Reactivating the cancelled timer
setting
Display the TIMER MENU and press the
6
buttons to choose which timer
setting to reactivate. Press the 5
buttons so that “Active” appears in the
Mode column.
Aborting timer recording
Display the Digital terrestrial broadcasting
(DVB-T) channel picture on the screen and
press the h (Information) button. A
window will appear asking if you want to
stop the recording. Press the a button to
abort the recording. If you want to continue
recording, press the TV/DTV button.
• If, while attempting to perform timer
recording to a T-V LINK compatible
VCR, the TV timer operation starts but
the VCR does not start recording, the
problem is with the VCR. Resolve the
VCR-related problem and see
“Aborting timer recording” to abort
the recording. After this is done, reset
the timer.
• When you are watching TV at the
recording start time, you may see an
error message stating that recording
could not start because of a VCR-
related problem. See “Direct Rec” on
page 13, which lists and explains each
error message.
LT-32&26D50BJSJ_Eng.book Page 29 Wednesday, September 8, 2004 2:59 PM