Jensen JMC-1100 - Manual (Page 13)

Set the FM mode selector at “ST” position for receiving stereo programs. The “ST” indicator
will appear on LCD to show fm stereo program is receiving.
Hints for Best Reception:-
- AM: The receiver has a built-in AM bar antenna. If AM reception is weak, slight rotate or
re-positioning of the unit will usually improve the AM reception.
- FM: The receiver has a build-in FM wire antenna hanging at the rear cabinet. This wire
should be totally unraveled and extended from best reception.
STEREO PHONOGRAPH OPERATION
Note Before Use
- Remove the stylus protector.
- Be sure that the tone arm is being detached from the tone arm rest
before operating, and re-secured again afterwards.
1. Raise the turntable dust cover.
2. Press the “PHONO” function button.
3. Set the 33/45/78 speed selector to the proper position depending on the
record to be played.
4. Place the record on the platter (use the 45 RPM record adaptor when
playing 45 RPM record).
5. Lift the tone arm from the rest and slowly move it to the record side. The
platter will being to rotate.
6. Place the tone arm to the desired position of the record.
7. Adjust the volume to the desired level.
8. At the end of record, the platter will automatically stop rotating. Lift the tone arm from the
record and return it to the rest.
9. To stop manually, lift the tone arm from the record and return it to the rest.
Remark: as some kind of record the auto-stop area was out of the unit setting, so it will stop
before the last track finish. in this case, select the auto-stop switch to “OFF” position, then it will
run to the end of the record but will not stop automatically (turn off the unit by power button or
switch back the auto-stop switch to “ON” position to stop the platter rotate). Then put back the
tone arm to the rest position.
PLAYING COMPACT DISC
LOADING THE DISCS
1. Press “CD” button.
2. Press “OPEN/CLOSE” button to open the CD door.
3. Place a CD with the printed side facing up inside the tray.
4. Press the “ ” or “ DISC-CH” button to turning the CD tray, and loading out the other disc
compartment.
5. Press the “OPEN/CLOSE” button again to close the CD door.
6. CD search is performing; the display will show the total number of disc, number of tracks and
playing time of disc.
Note: CD searching will be performed every time when switching to CD mode or closing the CD
door. All CD functions will be responded only after the CD searching is completed.
CD PLAY / PAUSE MODE
1. Press the “PLAY/PAUSE” button to start playback, the first track of the first disc will be played
and the play indicator will appear on the LCD display.
12
2. or press either the “ DISC 1”, “ DISC 2 ”, “ DISC 3 ” button, unit will play the disc inside the
desire tray directly.
3. To interrupt, press the “ PLAY/PAUSE ” button once, and the display will start flashing. Press