John Lewis JLSS2009 - Manual (Page 10)

10
19. Place the freezer door on the lower door retaining
pin (f) (Fig. 4).
20. Fix the double door mount with 2 screws (c) on the
left-hand side. Don't forget the plastic spacer under
the door (b) as well.The edges of the doors must run
parallel to the side edge of the appliance.
21. Place the fridge door on the double door retaining
pin.
22. Remove the top left-hand side door mount (f) and
the panel (c) from the plastic bag and attach using the
screws (c) (Fig. 1).
23. Open the fridge door, attach the top cover (j) using
2 screws (a); at the same time pay attention to the
repositioning of the magnet (k), then close the door
(Fig. 2).
24. Put over the handles (r) on the other side and put the
plastic blanking pins (p) supplied in the plastic bag of
this instruction book into the holes set free. (fig. 6)
25. Put the appliance into position, make adjustments if
not horizontal and connect to the electrical supply.
If you do not want to carry out these steps yourself, please
contact the nearest branded service point. Technicians will
make a charge for door reversal.
fig. 5.
fig. 6.
fig. 4.