John Lewis JLSS2009 - Manual (Page 13)

13
Select /Switch off /Switch on
each compartment
Temperature selection
The temperature may be regulated by pressing the key (D)
to select the compartment and then the key (B) to set the
desired temperature.
By pressing the key (B) the current temperature setting
flashes on the indicator. To confirm the choice of
temperature press the key (E).You will hear the buzzer for
few seconds and the indicator displays the newly selected
temperature for a few seconds, then shows again the inside
compartment temperature.
The newly selected-temperature will be reached after 24
hours.
The temperature will remain stored even if the product is
not in use.
Attention!
During the stability period by the first starting the
temperature displayed can not correspond to the setting
temperature. During this time it is possible that the
temperature displayed is different than the setting
temperature.
Switching off one compartment
To switch off one compartment press the key (D) until the
compartment is selected and then press hold of key (A), the
count down will begin.
Ambient Temperature Function
The ambient temperature function is activated by pressing
key D (several times if necessary) until the corresponding
icon appears .
In this condition the selected temperature is the ambient
temperature.
You must confirm the choice by pressing key E within a few
seconds.You will hear the buzzer and the icon will remain
lit. It is possible to de-activate the function at any time by
pressing key D until the corresponding icon will flash and
then press key E.
Child lock Function
The child lock function is activated by pressing key D
(several times if necessary) until the corresponding icon
appears .
You must confirm the choice by pressing key E within a few
seconds.You will hear the buzzer and the icon remains lit.
With this function activated, the programmed temperatures
and settings remain, even if any of the keys are pressed.
It is possible to de-activate the function at any time by
pressing key D until the corresponding icon flashes and then
pressing key E.