JVC VN-V225U series - Manual (Page 22)

22
Setting Using Internet Explorer
( TV) is applicable to VN-V series only. (TX) is applicable to VN-X series only.
Setting (continued)
A Camera ID Character strings entered here will be written to the JPEG comment segment
(item name: camera). Refer to the API Guide on the file formats of JPEG.
B Monitor Type For selecting the monitor type according to the monitor used to display the
video images. The picture quality varies according to the type of monitor
selected.
Custom
: Enables setting of picture quality according to the user’s
preference.
LCD1, LCD2 : Picture quality setting for LCD monitors. Two types are
available for selection according to the user’s preference.
CRT : Picture quality setting for CRT (cathode-ray tube) monitors.
[Set values: Custom, LCD1, LCD2, CRT]
Memo:
● Select ACustomB if you want to set the Gamma and Enhance frequency
values.
C Black Level For adjusting the black level. Lowering the value darkens the video image.
Increasing the value brightens the image.
[Setting range: 0 to 2]
Memo:
● If the black level is set to “0”, this may be too low depending on the
monitoring device, or dark area will become complete black.
● When using MPEG4 images, set to either “1” or “2”.
D Gamma To alter the appearance of dark areas in a video image, adjust the gamma
curve.
Off
: Do not perform gamma correction. The entire image appears dull.
-3 to 3 : Perform gamma correction. When this is set to “0”, standard gamma
correction is performed. Setting to a smaller value darkens the image,
while increasing the value brightens the image.
[Set values: Off, -3 to 0 to 3]
Memo:
● The set value is fixed when the monitor type is set to ALCD1B, ALCD2B, or ACRTB.
E Enhance
Frequency For setting the type of edge enhancement.
Low
: Enhances both thick and thin edges.
High : Enhances thin edges.
[Set values: Low, High]
Memo:
● The set value is fixed when the monitor type is set to ALCD1B, ALCD2B, or ACRTB.
F Enhance Level For setting the intensity of edge enhancement.
Larger value
: Increases the intensity of edge enhancement.
Smaller value : Decreases the intensity of edge enhancement.
[Setting values: -5 to 0 to 5]