JVC VN-V225U series - Manual (Page 44)

44
Setting Using Internet Explorer
Motion Detection Page (continued)
Memo:
● The area display position serves as a reference. Make sure to perform operation check.
● The screen is divided into blocks of 80 (10 horizontal x 8 vertical).
Set the angle of view such that the size of the object for which motion is to be detected is larger than
the size of multiple blocks.
Note:
● This feature may not function properly depending on the conditions of the object and settings.
● Flickers of fluorescent lamps may cause motion detection.
● Changes in brightness due to the light source may be detected as motion.
● The motion detection feature is not intended to prevent theft or fire.
● Our company shall not be liable for any accident or damage that occurs.
Setting (continued)
A Display Screen The screen is divided into blocks of 10 (horizontal) x 8 (vertical). You can
specify whether to enable motion detection in each block. Clicked block
turns blue. Click again to return to the original natural color. When the block
turns blue, it is unmasked and motion can be detected. Press the [OK]
button to enable this setting. When the screen of the block is in its natural
color, it is masked and motion cannot be detected in it. All blocks are
masked in the default setting.
Press the [OK] button to enable this setting.
Use the [Mask All] button to mask all blocks.
Use the [Clear Mask] button to unmask all blocks.
B Detection For setting motion detection to On/Off.
Press the [OK] button to enable motion detection in the unmasked blocks.
Memo:
● Even though motion detection is set to AOnB, the motion of masked
blocks cannot be detected.
C OK/Cancel To apply the new parameters, press the [OK] button. Press the [Cancel]
button to cancel the change.
D Level For setting the sensitivity of motion detection.
Increasing the number raises the detection sensitivity level, and hence it is
more sensitive.
Press the [OK] button to enable this setting.
[Set values : 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10]
E Mask All Masks all blocks.
Press the [OK] button to enable this setting.
F Clear Mask Unmasks all blocks and enables the current motion detection and detection
sensitivity settings.
Press the [OK] button to enable this setting.