JVC VN-V225U series User Manual
Page 75
75
(
TV) is applicable to VN-V series only. (TX) is applicable to VN-X series only.
Ⅵ Stream Settings
For specifying settings for receiving JPEG stream.
A
Stream
For selecting the protocol when the viewer acquires data from the
camera. When
AHTTPB is selected, lost packets are recovered via
resending. Camera may be monitored using multiple viewers when
AMulticastB is selected.
When playing back via multicast, start multicast sending on the
[Streaming] page. (
Note:
● When the built-in viewer is launched with AMulticastB specified, a
Windows firewall warning may appear. In this case, select
AunblockB
and proceed.
● If AblockB is selected, the Windows firewall will block the multicast
stream and playback of multicast by the viewer will fail.
B
HTTP Port
You can change the HTTP port number.
The default port number setting is 80.
Specify the same value as the parameter that is set on the Protocol page
of the camera. (
C
Frame Rate
For selecting the acquisition frame rate of the viewer.
Selecting a large frame rate will increase the processing load of the
computer on which the viewer is running.
[Set values : 30 (
TV), 25(TV) , 15 , 10 , 7.5 , 6 , 5 , 3 , 2 , 1 , 1/2 , 1/3 ,
1/5 , 1/10 , 1/15 , 1/20 , 1/30 , 1/60]
Note:
● Set to a rate such that the CPU burden of the computer does not
exceed 80 %. When the CPU is overloaded, the computer may not
function properly.
D
Multicast IP
Address
You can change the multicast IP address.
The default address is 225.0.1.1.
E
Multicast Port
You can change the multicast port number.
The default port number setting is 49152.
This is enabled when
AStartB is selected for the [JPEG Control] item on
the[Control] page.
Specify the same value as the parameter that is set on the [Streaming]
page of the camera. (
Ⅵ Other
A
Folder Name
For specifying the name of the folder in which the captured files are
stored. (Default name when viewer is installed:
Amodel nameB
(E.g.,
AVN-V225B folder is made for AVN-V225VPUB)