JVC KY-F1030U - Manual (Page 41)

E37
PROCESS screen
[ ] indicates the factory setting
Item
DETAIL
LEVEL
When “ON” is
selected
NOISE SUP.
When “ON” is
selected
GAMMA
MASTER BLACK
FLARE
LEVEL (R)
When “ON” is
selected
L E V E L ( B )
When “ON” is
selected
Set Value
[ON]
OFF
–7
–6
•
[NORMAL]
•
7
[OFF]
LOW
MIDDLE
HIGH
[ON]
OFF
–32
–31
•
[0]
•
31
[ON]
OFF
–32
–31
[NORMAL]
•
31
–32
–31
[NORMAL]
•
31
MEMO
Note that when the noise reduction is increased, de-
tails may get lost in the coarse parts of the image.
Contents
Used to set whether to emphasize details (contours).
ON:
Detail emphasis is performed.
OFF: Detail emphasis is not performed.
When [DETAIL] is set to “ON”, the emphasis level of the
detail is adjusted.
Increasing the value:
Sharpens details
Decreasing the value: Softens details
Reduces noise in the video signal.
OFF:
Noise reduction is not performed.
LOW, MIDDLE, HIGH: Noise reduction is performed.
The reduction rate increases in the order of LOW
➝
MIDDLE ➝ HIGH.
ON: The video signal is compensated to make the
image viewed on the screen natural.
OFF: No compensation and the video signal is out-
put linearly.
Used to adjust the pedestal level (master black), which is
the standard of black when the lens is capped. To see
more details in black areas, raising the pedestal level will
brighten the entire screen.
Increasing the value:
Raises the pedestal level
Decreasing the value: Lowers the pedestal level
Compensation of the black level when flaring effect oc-
curs and black areas are tinted with color due to irregular
reflection of light entering the lens.
Compensation of the black level of Rch
Increasing the value: Red tint becomes weaker
Decreasing the value: Red tint becomes stronger
Compensation of the black level of Bch
Increasing the value:
Blue tint becomes weaker
Decreasing the value: Blue tint becomes stronger