JVC UX-A10DVD - Manual (Page 49)

46
English
2) Press the character entry button for a character
you want to enter.
Ex.:
• To enter an “A” or “a,” press ABC once.
To enter a “B” or “b,” press ABC twice.
To enter a “C” or “c,” press ABC three times.
• To enter a symbol, press MARK repeatedly until
the mark you want appears.
Available symbols:
• To enter a numeral, press 0 – 9.
• To enter a space while entering a title, press
Cursor
3 twice.
• To move the character entry position while
entering a title, press Cursor
3 or 2.
• If you have entered an incorrect character, press
Cursor 3 or 2 to select the character you want to
correct, then press CANCEL to delete it.
3) Repeat steps 4 – 1) and 4 – 2) to enter other
characters.
• If the character you want to enter next is assigned
to the same button you have just pressed in step
4 – 2), press Cursor
3 once to move the character
entry position to the right.
5
Press ENTER.
“SEARCH ........” scrolls and the TITLE and SEARCH
indicators start flashing on the display. The unit starts
searching for the track.
• When the track with the desired title is found, the unit
plays back the track. (After the track is played, the
unit starts searching for the next matching track.)
• If no track with the desired title is found, “SEARCH
END” appears in the main display and Normal play
mode resumes (the TITLE and SEARCH indicators
go off).
To skip the current playing track and search for the
next track, press
¢.
To cancel the title searching, press TITLE SEARCH
while holding down SHIFT.
When you press the buttons during playback or search,
normal play resumes.
Searching for Tracks to Play
—MD Title Search
You can search for the tracks by their titles and play them
back.
For details on assigning a title, see pages 80 to 82.
On the remote control ONLY:
1
Load an MD.
2
Press MD 3/8, then 7.
The source is changed to “MD” and playback is
stopped.
3
Press TITLE SEARCH while holding down SHIFT.
“TITLE” and the character entry position appear in the
main display and the TITLE SEARCH indicator lights
up on the display.
The play mode changes to normal play.
4
Enter the character(s) to search for the track title.
You can enter up to 5 characters. The unit will search
for the tracks which have the entered characters at the
head of their titles.
• You can also search for the tracks which do not have
a title. In this case, go to step 5 without entering any
character.
1) Press DISP/CHARA to select the character set
you want.
• Each time you press the button, the character set
changes as follows:
TITLE SEARCH indicator
Character entry position
Character set
Capital letters &
Symbols
Small letters &
Symbols
Numerals
(Blank)
EN40_46UX-A10DVD[UB].pm6 02.10.7, 8:10 AM 46