JVC UX-A10DVD - Manual (Page 64)

61
English 4
Press ONE TOUCH MD REC on the main unit.
• When recording from an FM/AM broadcast or a tape,
recording starts and the MD REC indicator starts
flashing on the display.
• When recording from external equipment, the
following indication appears in the main display.
–When “AUX” is selected: “AUX
= MD”
–When “AUX-DIGITAL” is selected:
“AUX-D = MD”
When recording from external equipment, go to step 5.
5
Starts playback on external equipment.
When the sound from external equipment comes into
the unit, recording starts.
To set a track mark manually while recording, press
SET on the remote control at the place where you want.
When “AUX-DIGITAL” is the source to record
You cannot set a track mark manually while recording.
To stop recording, press
7.
“WRITING” flashes in the main display for a while.
To change the information shown in the main display
On the remote control ONLY:
Press DISP/CHARA.
• Each time you press the button, the information in the
main display changes as follows:
Recording Other Sources onto an MD
• Digital recording method is used for AUX-DIGITAL-to-
MD recording, while analog recording method is
used for FM/AM/AUX-to-MD recording.
Sound synchronized recording
When recording from external equipment, recording
starts automatically when the source sound comes into
the unit, and stops automatically if no sound comes into
the unit for more than 30 seconds.
1
Prepare the source to record.
To record from FM/AM broadcasts:
Press FM/AM (or FM/AM/AUX on the remote control)
to select either “FM” or “AM,” then tune in to the
station you want.
• For more detailed tuner operations, see pages 25 and
26.
To record from a tape:
1) After putting a cassette, press TAPE
@ #, then 7 to
select “TAPE” as the source.
2) Press REV. MODE to select the reverse mode (see
page 48).
To record from external equipment:
Press AUX (or FM/AM/AUX on the remote control)
repeatedly to select “AUX” or “AUX-DIGITAL” and
prepare the external equipment.
• Adjust audio input level through the AUX jacks or
the OPTICAL DIGITAL IN terminal if necessary
(see page 23).
• For operation of the external equipment, see its
manual also.
2
Insert a recordable MD into the MD loading slot.
3
Set the MD recording length mode, “LP:”-prefix
addition mode, and the group recording mode.
See “Setting MD Recording Modes” on page 59.
Ex.: When you record an FM broadcast.
1 Source indication
2 Remaining recording time
3 MD track No.
4 MD group No. (When the group recording is not
activated, “– –” will appear.)
4 2
1
3
Clock time
MD and MD REC indicator are flashing.
Ex.: When recording from “AUX-DIGITAL” using the
group recording.
EN56_64UX-A10DVD[UB].pm6 02.10.7, 8:11 AM 61