Johnson Controls Residential Gas TM9V MP - Manual (Page 18)

438335-UIM-B-0509
18 Johnson Controls Unitary Products
FIGURE 24: Upflow Configuration
INDUCER ROT
A
TED FOR
LEFT
SIDE VENTING
UPFLOW
AS RECEIVED
INDUCER ROT
A
TED FOR
RIGHT
SIDE VENTING
When drain hose routing changes are required, be sure to cap all un-used openings. If rerouting hoses - excess length should be cut of
f so that no sagging loops will collect
and hold condensate, which will cause the furnace to not operate.
Shorten pressure
switch hose.
Re-route and shorten pressure switch hose.
Shorten rain
gutter hose.
Move rain gutter hose to this position.
For 100, 120K input furnaces, the condensate drain is
plumbed toward the left casing outlet from the factory.
For 060 & 080K input furnaces, the condensate drain
is plumbed toward the right casing outlet from the factory.
Condensate drain may exit cabinet on either side.
1
2
1
2