JVC Model 200 User Manual
Service manual
Advertising
Table of contents
Document Outline
- Safety Information
- 1.0 Introduction
- BCH2SYDS.pdf
- 2.0 System Description
- Contents
- 2.1 Introduction
- 2.2 Optical System
- 2.3 Electronics System
- 2.3.1 General Description
- Figure 2-2. Model 200 System Block Diagram
- 2.3.2 Power Supplies
- 2.3.3 Video Input Cards
- Standard RGB Video Input Card (RGB_VIC)
- Quad Input RGB VIC
- HDTV YPbPr VIC
- Quad Standard Decoder VIC
- 2.3.4 Video Processor PCB
- 2.3.5 Video Amplifier
- 2.3.6 System Controller PCB
- 2.3.7 Raster Timing Generator PCB
- 2.3.8 Horizontal/Vertical Deflection PCB
- 2.3.9 Convergence/Deflection PCB
- 2.3.10 Scan Reversal Board
- 2.3.11 Backplane PCB
- 2.4 Image Light Amplifier Technology
- 2.0 System Description
- CCH3SADJ.pdf
- 3.0 Service Adjustments
- Contents
- 3.1Arc Lamp Focus and Alignment
- 3.2Arc Lamp Current Setting
- 3.3Electronic Module Tilt-up
- 3.4ILA® Back Focus
- 3.5CRT Mechanical Focus
- 3.6CRT Rotation
- 3.7CRT Electronic Focus
- 3.8ILA® Overlap
- 3.9Front/Rear or Inverted Projection Jumper Settings
- 3.10Vertical and Horizontal Size Settings
- 3.11Software Updating
- 3.12Cleaning Lenses, ILA® Assemblies and Mirrors
- 3.0 Service Adjustments
- DCH4MAIN.pdf
- 4.0 Maintenance (Removal/Replacement)
- Contents
- 4.1 Introduction
- 4.2 Projector Covers
- 4.3 Air Filters
- 4.4 Arc Lamp Assembly
- 4.5 Arc Lamp Power Supply
- 4.6 Low Voltage Power Supply
- 4.7 High Voltage Power Supply
- 4.8 Raster Timing, System Controller, Video Processor PCBs
- All electrical connections to the Raster Timing Generator, System Controller, and Video Processor boards are routed through the backplane board. There are no connectors to remove.
- NOTE: To remove connectors on the printed circuit boards below, push the connector in slightly, then squeeze the tab and pull the connector out.
- 4.9 Convergence/Deflection PCB.
- 4.10 Horizontal/Vertical Deflection PCB
- 4.11 Video Input Cards (VICs)
- 4.12 Video Amplifier PCB
- 4.13 Scan Reversal PCB
- 4.14 CRT/Yoke Assembly
- 4.15 ILA® Assembly
- 4.16 Relay Lens
- 4.17 Projection Lens
- 4.18 Prism Assembly
- 4.0 Maintenance (Removal/Replacement)
- ECH5TSHO.pdf
- HGLOSSRY.pdf