JVC RD-MD5 - Manual (Page 8)

5
■ ■
Common Operations
PHONES
SUPER
WOOFER
VOLUME+,–
DISPLAY
/CHARA.
DISPLAY
ACS
VOLUME+,–
TREBLE+,– MID+,–
SUPER
WOOFER
VOLUME+,– STANDBY
indicator
ACTIVE CLEAR
SOUND indicator
ACTIVE CLEAR SOUND
VOLUME+,–
MID/TREBLE
Turning the System On ——————
Press the button.
The display comes on and the “STANDBY” indicator goes out.
The System comes on ready to continue in the mode it was in when
the power was last turned off.
■
For example, if the last thing you were doing was listening to a
CD, you are now ready to listen to a CD again. If you wish, you
can change to another source.
■
If you were listening to the Tuner last, the Tuner comes on play-
ing the station it was last set to.
Turning the System Off ——————
Press the button again.
The "STANDBY" indicator lights up and the display is blank, ex-
cept for the clock display.
■
Some power is always consumed even though power is turned
off (called Standby Mode).
■
To switch off the System completely, unplug the AC power
cord from the AC outlet. When you unplug the AC power cord,
the clock will be reset to 0:00 after about 5 minutes, and preset
Tuner stations will be erased after about 24 hours.
You can adjust the volume level between 0 and 50.
Press the VOLUME + button to increase the volume or press the
VOLUME – button to decrease it.
When you keep pressed the VOLUME + or – button, the VOLUME
indication changes rapidly.
CAUTION: DO NOT start playing any source with-
out first setting the VOLUME control to minimum
position, as a sudden blast of sound can damage
your hearing, speakers and/or headphones.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers.
Be sure to turn down the volume before connecting or putting on
headphones.
You can adjust the bass level between BASS 1 (minimum) and
BASS 6 (maximum). You can use this effect only for playback.
Press the SUPER WOOFER VOLUME + button to increase the
bass level or press the SUPER WOOFER VOLUME – button to de-
crease it.
Note: This function is not effective when the headphones are in
use.
You can control the tone by changing the mid and the treble be-
tween –6 and +6. (0: Flat)
Using the Unit ———————————
■
1. Press the MID/TREBLE button to select MID
or TREBLE.
Each time you press the button, the display changes as follows.
Current sound source (e.g. FM103.50MHz) =MID 0=
TREBLE 0 =(back to the beginning)
■
2. Press the VOLUME + or – button within 4
seconds to adjust the mid/treble level.
Using the Remote Control —————
Press the MID+ or MID– button to adjust the mid level between
MID – and MID +6.
Press the TREBLE+ or TREBLE– button to adjust the treble level
between TREBLE – and TREBLE +6.
Turning the Power On and Off
Adjusting the Volume
or or
or or
Adjusting the Super Woofer Vol-
ume
Tone Control (MID/TREBLE)
or or
RD-MD5(B)-e.fm Page 5 Wednesday, December 2, 1998 11:40 AM