JVC HM-DSR100U - Manual (Page 163)

Page 7-17
Installing and Wiring Your System
Ordering Your Programming
7
O
RDERING
Y
OUR
P
ROGRAMMING
This procedure notifies the Service Center that your system is on-line and installed.
You need to have your services activated before you can start enjoying your desired
programming. You must authorize your services when you first install your system, and
whenever you request to add or remove services.
All you need to do is call to notify the Service Center that your system has been installed
and you would like to begin receiving programming. The Service Representative will
explain the available program packages and services. You can then select the services that
you want to authorize.
You will need to give the Service Representative information about your system. To get this
information, do the following: Power the recorder OFF, using the remote control
Power
button (not the recorder Power button). Then, press the Info button on the recorder or
remote. This will display the Important System Information menu, as shown below. To
exit this menu, press the Select button on the recorder or remote.
Note: The recorder is still OFF. You will have to press the Power button on either the
remote or the recorder to turn the recorder back ON.
S
ERVICE
C
ENTER
P
IN
As an option, the Service Representative will ask you if you want to set up a Service Center
Personal Identification Number (PIN). See Service Center Security on page 4-29 for more
information.
Important System Information
OK
Copyright © 1996, EchoStar Communications
Corporation. All Rights Reserved.
Model ID: IRR
Receiver CA ID: R0016825089-94
Smart Card CA ID: S0000278950-56
DNASP002 Rev052
Software Version: 205PBTAA-F
Boot Strap Version : 100BBTAA
Customer Service: 1-800-333-DISH (3474)
Internet Address: http://www.dishnetwork.com
Remote Address: 9
Model ID
SmartCard
Conditional
Access Number
Access to
Assistance
Press Select
to Exit Info
Screen
Receiver
Condtional
Access
Number
Software
Versions
Remote
Control
Address
Info screen
Title
The Service Representative will authorize your programming signal
using the satellite signal. This includes checking that the Smart Card is
properly inserted in the recorder.
When the services are authorized, you should see channels other than the
Preview Channel.