JVC HM-DSR100U - Manual (Page 27)

Page 3-1
3
U
SING THE
R
EMOTE
C
ONTROL
I
NSTALLING
B
ATTERIES IN THE
R
EMOTE
The remote control is shipped with four AAA batteries, packaged separately.
When you replace old batteries, you should replace all four batteries. Use four
batteries of the same grade, for example, alkaline or carbon zinc, and do not
mix batteries of different grades. Alkaline batteries provide longer battery life.
Any time you remove or install the batteries, you may have to reprogram the
remote for the TV and any other electronic components. See Programming the
Remote Control on page 4-39 for the procedure to reprogram your remote.
1. Press down on the slot in the battery case
cover (on the back of the remote) and
remove the cover.
2. If you are replacing old batteries, remove
and replace all four batteries.
3. Insert the new batteries, making sure to
match the plus (“+”) ends with the plus
indicators on the remote. The batteries
alternate plus and minus (“–”) ends when
properly seated.
4. Replace the cover by inserting the tabs
into the slots, and snapping the cover into
place.
If the remote does not work after installing the batteries, confirm that the batteries are
properly seated, with the plus and minus ends aligned correctly. You may need to reprogram
the remote. See Programming the Remote Control on page 4-39.
Getting Started
Battery Cover
Back of
Remote
Batteries