JVC BR-DV6000 - Manual (Page 12)

12
4
[REMOTE/LOCAL] switch
This switch is used to select how BR-DV6000
is to be operated.
LOCAL
: Use this setting if BR-DV6000 is to
be controlled with the key operation
of the unit.
REMOTE : Use this setting if BR-DV6000 is to
be controlled using the edit control-
ler connected to the REMOTE 1 (9-
PIN) terminal or REMOTE 2 (12-
PIN) terminal.
When it is set to REMOTE, settings
can be performed at the REMOTE
(1/2) MENU screen to enable/dis-
able operation via the 9-PIN or 12-
PIN REMOTE terminal.
The 9-PIN REMOTE 1 terminal can
be selected using REMOTE SEL 9
PIN while the 12-PIN REMOTE 2
terminal can be selected with RE-
MOTE SEL JVC.
5
[INPUT SELECT] switch
This switch is used to select input signals.
DV
: For DV signals of the DV IN/OUT
terminal (IEEE1394)
LINE : For inputting the composite images
of the LINE IN terminal and ana-
log audio signals.
Y/C (CPN) : For inputting the YC separate video
signal of the Y/C IN terminal and
the component video signal of the
COMPONENT IN terminal. The
selection of the YC separate sig-
nal or the component video signal
can be done with VIDEO INPUT
SEL in the VIDEO MENU screen.
For audio, analog sound is input.
6
[AUDIO OUTPUT] switch
Use this switch to select the audio channel from
the headphone terminal and the AUDIO OUT
terminal located on the rear panel.
This switch is valid in the following conditions.
• During playback of tapes recorded in the 32k
audio mode
• In the EE mode for DV input in the 32k audio
mode
• During audio dubbing
CH-1/2
: For outputting the sound of the
channels CH1 and CH2.
MIX : For outputting the mixed sound of
CH1 and CH3 from the CH-1/3 AU-
DIO OUT terminal and the mixed
sound of CH2 and CH4 from the CH-
2/4 AUDIO OUT terminal.
CH-3/4 : For outputting the sound of CH3 and
CH4.
BR-DV6000
PROFESSIONAL
MENU RESET A.DUB
EJECT
COUNTER
AUDIO INPUT
SELECT MONITOR OUTPUT REMOTE
LOCAL
CTL L
MIX
R
CH-1/2
MIX
CH-3/4
DV
LINE
Y/C
(CPN)
TC
UB
REW STOP FF
REC
OPERATE
PLAY PAUSE DISP
SET
BLANK CUE UP HOLD
PHONES REC LEVEL
CH-1/3 CH-2/4
MIC
Mini
9 8 7 6 5 4
SEARCH+ SEARCH–
NAMES AND FUNCTIONS
OF PARTS
– Front panel – (continued)
Memo
● To control BR-DV6000 with the SERIAL RE-
MOTE terminal or DV terminal, this switch set-
ting can be set up with REMOTE SEL SE-
RIAL or REMOTE SEL DV in the REMOTE
(1/2) MENU screen. (
☞
Page 75)
● If it is set to REMOTE, the buttons that can
be operated from the unit are selectable from
LOCAL FUNCTION in the REMOTE (1/2)
MENU screen.
Note
Switching is invalid during recording.
DV6000U_02-027_Eng.p65e 06/03/03, 11:39 PM 12