JVC BR-DV6000 - Manual (Page 35)

35
VIDEO LINE
IN
OUT
MONITOR
OUT
DC12V
DV
IN/OUT
IN OUT OFF
AUDIO
REMOTE2
IN B-Y R-Y
SYNC IN TIME CODE IN OUT
Y
COMPONENT
OUT CH 1/3 CH 2/4
IN
OUT
MONITOR
OUT REMOTE1
TIMER
REC PLAY
SERIAL
REMOTE SIGNAL
GND
Y/C
DV6000
ONAL
A.DUB
EJECT
COUNTER
AUDIO INPUT
SELECT MONITOR OUTPUT REMOTE
LOCAL
CTL L
MIX R
CH-1/2
MIX CH-3/4
DV
LINE Y/C
(CPN)
TC
UB
REW STOP FF
REC
OPERATE
PLAY PAUSE
Ⅵ Before connecting the AC adaptor, en-
sure that the TIMER switch is set to
“OFF”. (Refer to “Notes” below.)
1.
Connect the DC cord of the AC adapter to
the DC IN terminal of BR-DV6000.
2.
To prevent accidental disconnection of the
DC cord, fasten the DC cord with a clamp.
1Remove the screw and the clamp shown in
the above figure.
2Insert the DC cord into the clamp and fasten
the clamp unto the unit.
3.
Connect the supplied power cord to the AC
IN terminal of the AC adapter.
4.
Connect the power cord to the power outlet.
• BR-DV6000 is turned on and the OPERATE
indicator lights up in red.
(OPERATE OFF mode)
• If DC IN MODE of the SYSTEM (2/2) Menu
screen is set to “OPE ON”, the OPERATE in-
dicator will light up in green.
(OPERATE ON mode)
Memo
● Even in the OPERATE OFF mode, a small
amount of electricity will still flow into the unit.
● When the unit is in the OPERATE OFF mode,
no operation can be performed except that
of the OPERATE buttons and cassette load-
ing/ejecting.
Notes
• Supply power to BR-DV6000 using the supplied AC adapter. Do
not use other power sources.
• Do not unplug the DC cord and/or the power cord during recording
or playback.
• If the supply voltage is low, an alarm display of “LOW VOLTAGE” is
shown.
• If the TIMER switch is set to REC or PLAY, recording or playback
begins when power is supplied to the DC IN terminal.
When the AC adapter is connected, ensure in particular that the
TIMER switch is not set to REC.
Set the TIMER switch to REC or PLAY only when an external timer
function is used.
LOW VOLTAGE
Alarm message
Supplied power
cord
Supplied AC adaptor
Screw
Clamp
DC cord
DC IN
terminal
TIMER switch
OPERATE indicator
OPERATE button
CONNECTION
– Connecting the AC adapter –
Connect the supplied AC adaptor to BR-DV6000.
DV6000U_28-051_Eng.p65e 06/03/03, 11:39 PM 35