Install an hfc connector module or sim, Figure 32: docsis module installation – Juniper Networks G10 CMTS User Manual
Page 121
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Install the CMTS
Install an HFC Connector Module or SIM
105
Figure 32: DOCSIS Module Installation
Install an HFC Connector Module or SIM
To install an HFC Connector Module or SIM, follow this procedure:
1.
If applicable, remove the air management panel from the slot by loosening the two
self-contained screws at the top and bottom of each panel.
2.
Remove the module from its anti-static bag, being careful to avoid directly touching any
component on the module. We recommend that you handle the module by by its card
edges or ejectors.
1
2
2
Unlike a DOCSIS Module, the ejectors on a rear module
lock in the horizontal position (90° from the faceplate)
when the module is properly installed into its card slot.