John Lewis JLTDH15 - Manual (Page 25)

Appliance positioning
• It is recommended that, for your
convenience, the machine is positioned
close to your washing machine.
• The tumble dryer must be installed in a
clean place, where dirt does not build up.
• Air must be able to circulate freely all
round the appliance. Do not obstruct the
front ventilation grille or the air intake
grilles at the back of the machine.
• To keep vibration and noise to a
minimum when the dryer is in use, it
should be placed on a firm, level surface.
• Once in its permanent operating position,
check that the dryer is absolutely level
with the aid of a spirit level. If it is not,
raise or lower the feet until it is.
• The feet must never be removed. Do not
restrict the floor clearance through
deeppile carpets, strips of wood or
similar. This might cause heat built-up
which would interfere with the operation
of the appliance.
Important!
• The appliance should not be installed in an
environment such as a unheated garage or
outbuilding. The combination of high
humidity and low ambient temperatures
could affect the performance or the
appliance and therefore invalidate your
guarantee.
• The hot air emitted by the tumble dryer
can reach temperatures of up to 60°C.
The appliance must therefore not be
installed on floors which are not resistant
to high temperatures.
• When operating the tumble dryer, the
room temperature must not be lower
than +5°C and higher than +35°C, as it
may affect the performance of the
appliance.
• Should the appliance be moved, it must
be transported vertically.
• The appliance must not be installed
behind the lockable door, a sliding door a
door with a hinge on the opposite side to
that of the appliance in such a way that a
full opening of the dryer is restricted.
Removing transport
safety packaging
Caution! Before use all parts of the
transport packaging must be
removed.
1. Open loading door
2. Pull off adhesive strips from inside
machine on top of drum.
25