John Lewis JLTDH15 - Manual (Page 26)

3. Remove foil hose and polystyrene
padding from the machine.
Warning! If the appliance was not
transported in an upright position,
leave it to stand for 12 hours before
connecting it to the electricity supply
and using it for the first time, so that
the oil can flow back to the
compressor. Otherwise the
compressor could be damaged.
Electrical connection
Any electrical work required to install this
appliance should be carried out by a
qualified electrician or competent person.
Warning! THIS APPLIANCE
MUST BE EARTHED.
Should the appliance power
supply cable need to be
replaced, this must be carried
out by a Service Force agent
(see chapter: Repairs - after
sales service).
The manufacturer declines any
liability should this safety
measure not be observed.
Before switching on, make sure the
electricity supply voltage is the same as that
indicated on the appliance’s rating plate.
(See picture on page 6).
The appliance is supplied with a 13amp plug
fitted. In the event of having to change the
fuse in the plug supplied, a 13amp ASTA
approved BS 1363/A fuse must be used.
Should the plug need to be replaced for any
reason, proceed as described below. The
wires in the mains lead are coloured in
accordance with the following code:
• Green and Yellow - Earth
• Blue - Neutral
• Brown - Live
GREEN & YELLOW
BROWN
CORD CLAMP
BLUE
26