Juniper Networks RELEASE 8.1.X E320 - Manual (Page 15)

SFM-100 Module
SFM-100 Module label
■ Not applicable IOA label
■ Not applicable Number of IOA ports
■ First supported: 7.0.1 Software release
■ 40 W
■ Switch fabric module (100 Gbps)
■ Works with the SRP-100 module to create a switch fabric
■ Must be installed only with SRP-100 module and SFM–100 modules
Description
■ Not applicable Capability
■ Not applicable Software features
■ ES2 4G LM
■ ES2 10G UPLINK LM
Line module compatibility
■ SRP-100
■ Cannot use with SRP-320 module or SFM-320 module
SRP module compatibility
■ N+1 redundancy Module redundancy support
■ Not applicable Port redundancy support
■ Not applicable Cables and connectors
When lit, LED indicates:
■ OK (green)—Self-test passed
■ FAIL (red)—Failure detected
■ ONLINE (green)—Online with no alarms or errors
■ REDUN (green)—N+1 redundancy is enabled; 2 SRPs and 3 SFMs must be
installed and working. When LED is unlit, one of the five fabric slices is down
or not installed; N+1 redundancy is not enabled.
NOTE: When REDUN LED is on, the module may be removed without interrupting
service.
LEDs
■ See Monitoring Modules in JUNOSe System Basics Configuration Guide, Chapter 6,
Managing Modules. Alarms, errors, and events
SFM-100 Module ■ 15
SFM-100 Module