Juniper Networks RELEASE 8.1.X E320 - Manual (Page 9)

LM-10 Line Module
ES2 10G LM Module label
■ Not applicable Number of ports
■ First supported: 8.0.0 Software release
■ 215 W
■ Acts as frame forwarding engines for the physical interfaces
■ Processes up to 10 Gb of data traffic
■ Pairs with ES2–S2 10GE PR IOA and ES2–S1 GE-8 IOA
■ In a SRP-100 configuration, it must be installed in a turbo slot only (slot 2 or slot 4)
■ If you install the line module in a slot other than slot 2 or slot 4, it will be disabled
■ If you install the LM-10 module next to a configured line module that is already
installed in slot 3 or slot 5, the LM-10 module will be disabled
■ If you install a line module in slot 3 or slot 5 next to a previously installed LM-10
module, the non-LM-10 module will be disabled
■ In a SRP-320 configuration, it can be installed in any slot
Description
■ Supports a line rate of 128–byte frames on IOAs
■ The 100–Gbps switch fabric allocates 3.4 Gbps of overall bandwidth to each regular
line module slot and 10 Gbps of overall bandwidth to each of the turbo slots (slot 2
and slot 4).
■ The 320–Gbps switch fabric allocates 10 Gbps of overall bandwidth to each line module
slot.
■ See JUNOSe System Basics Configuration Guide, Chapter 6, Managing Modules for more
information.
Capability
■ Not applicable Software features
■ Not applicable Line module compatibility
■ SRP-100
■ SRP-320
SRP module compatibility
■ Yes (Redundancy IOA must be installed in either slot 0 or slot 11)
■ Can only backup another ES2 10G LM
Line module redundancy
compatibility
■ Not applicable Port redundancy support
■ Not applicable Cables and connectors
LM-10 Line Module ■ 9
LM-10 Line Module