Others, Setup menu – JVC BD-X200E User Manual
Page 60
E
U
95
NETWORK MENU Screen
The following table identifies and describes the parameters that may be set using the NETWORK MENU screen.
Top half
: Appearance on monitor screen
Bottom half : Appearance on LCD display
[ ]
: Default setting
Parameter
Possible settings
Description
HOST NAME
bdx200
CANCEL
HoST
IP ADDRESS
[192.168.0.2]
IP Add
[192]
SUBNET MASK
[255.255.255.0]
SUbNET
[255]
DEFAULT
[192.168.0.254]
GATEWAY
GATE
[192]
MENU
This parameter is used to enter the BD-X200’s network name using a keyboard.
The name cannot be input from the BD-X200.
(Names may be up to 20 characters in length. Alphanumerical characters and hyphen
(-))
CANCEL : Cancel setting the host name.
This parameter is used to set the IP address. It is important to ensure that no two
devices on a single network share the same IP address.
This parameter is used to set the subnet mask. Connected BD-X200s should have
the same network setting.
This parameter is used to set the gateway address. Connected BD-X200s should
have the same address.
This button is used to return to the Setup Menu screen.
Others
Troubleshooting
Before requesting for repair, please check the following URL:
http://www.jvc-victor.co.jp/english/pro/prodv/
If problem persists, contact either the store where the BD-X200 was purchased or your nearest JVC authorized dealer.
* The IP ADDRESS SETTING item cannot be selected.
E-94
NETWORK MENU Screen
The following table identifies and describes the parameters that may be set using the NETWORK MENU screen.
Top half
: Appearance on monitor screen
Bottom half : Appearance on LCD display
[ ]
: Default setting
Parameter
Possible settings
Description
HOST NAME
bdx200
CANCEL
HoST
IP ADDRESS
[192.168.0.2]
IP Add
[192]
SUBNET MASK
[255.255.255.0]
SUbNET
[255]
DEFAULT
[192.168.0.254]
GATEWAY
GATE
[192]
MENU
This parameter is used to enter the BD-X200’s network name using a keyboard.
The name cannot be input from the BD-X200.
(Names may be up to 20 characters in length. Alphanumerical characters and hyphen
(-))
CANCEL: Cancel setting the host name.
This parameter is used to set the IP address. It is important to ensure that no two
devices on a single network share the same IP address.
This parameter is used to set the subnet mask. Connected BD-X200s should have
the same network setting.
This parameter is used to set the gateway address. Connected BD-X200s should
have the same address.
This button is used to return to the Setup Menu screen.
Others
Troubleshooting
Before requesting for repair, please check the following URL:
http://www.jvc-victor.co.jp/english/pro/prodv/
If problem persists, contact either the store where the BD-X200 was purchased or your nearest JVC authorized dealer.
* The IP ADDRESS SETTING item cannot be selected.
Setup Menu