SUPER MICRO Computer MICRO COMPUTER MOTHERBOARD P8SC8 - Manual (Page 26)

2-6
P8SC8/P8SCi User's Manual
Figure 2-2. DDRII Installation
To Install:
Insert module
vertically and
press down
until it snaps
into place.
Pay attention
to the notch.
II
To Remove:
Use your thumbs
gently to push
each release tab
outward to
release the DIMM
from the slot.
DDRII Slot
(Top View)
Support
The P8SC8/P8SCi supports Dual channel, ECC/Non ECC, unbuffered
DDR2 533/ 400 SDRAM. Both interleaved and non-interleaved memory
are supported, so you may populate any number of DIMM slots. (Popu-
lating DIMM#1A, DIMM#2A, and/or DIMM#1B, DIMM#2B with memory
modules of the same size and of the same type will result in dual
channel, two-way interleaved memory which is faster than single
channel, non-interleaved memory.)
2-4 Installing DDR2 Memory
CAUTION
Exercise extreme care when installing or removing memory
modules to prevent any possible damage.
Memory Module Installation (See Figure 2-2)
1. Insert each DDR2 memory module vertically into its slot. Pay attention
to the notch along the bottom of the module to prevent inserting the
module incorrectly. (See support information below.)
2. Gently press down on the memory module until it snaps into place.