Schneider Electric 66123 - Manual (Page 41)

Network Management Card & Modbus/Jbus 34022321XT indice :AE Page 41/98
Network Management Teleservice Card
APC by Schneider Electric
www.apc.com
6.4.1 Network settings
Click on "Network" in the menu.
This menu enables the administrator to configure the network parameters of the card and authorisation of the remote upgrade of the embedded
system.
IP Address: The IP address of the card (e.g.: 172.17.22.252).
Subnet Mask: The mask of the sub-network of your network (e.g.: 255.255.255.0).
Gateway Address: Indicate the IP address of the gateway to access the stations located outside the card’s subnet (e.g.: 172.17.17.1).
Hostname must be suited to the card. This is the first part of the fully qualified domain name, used by the DNS.
As the card does not support NetBIOS protocol, the hostname will only be sent to DNS if the DHCP server sends it the hostname with the new
IP address. This mechanism is described in the update of the DNS protocol RFC 2136
Domain Name is the domain to which the card belongs. This is the part of the fully qualified domain name that follows the hostname and is
used by the DNS. The default value of the two parameters comprising the fully qualified domain name: ups.domain.com