Schneider Electric 66123 - Manual (Page 62)

Network Management Card & Modbus/Jbus 34022321XT indice :AE Page 62/98
Network Management Teleservice Card
APC by Schneider Electric
www.apc.com
9.2 Choice 2: Network Configuration
Use this function to access network settings.
-----------------------------------------------------------------------------
Network settings
-----------------------------------------------------------------------------
1 : Read Network settings
2 : Modify Network settings
3 : Set Ethernet speed
0 : Exit
-----------------------------------------------------------------------------
9.2.1 Choice 1: Read Network settings
Enables reading of the card's routine settings
Network configuration :
MAC address : 00:06:23:00:1F:8F
Mode : Static IP
IP address : 172.17.18.129
Subnet mask : 255.255.248.0
Gateway : 172.17.17.1
9.2.2 Choice 2: Modify Network settings
Enables the modification of network parameters
For each of the following questions, you can press <Return> to select the value
shown in braces, or you can enter a new value.
Should this target obtain IP settings from the network?[N]
Static IP address [172.17.18.129]?
Subnet Mask IP address [255.255.248.0]?
Gateway address IP address [172.17.17.1]?
Wait during your new configuration is saved ...
Reset the card to take into account the new configuration.
In DHCP mode, the card can receive the following parameters according to the DHCP server settings
IP address
Subnet Mask
Gateway address
Primary DNS server
Secondary DNS server
The card must be restarted in order for the new parameters to be taken into account.