Sony WEGA KLV-17HR2 - Manual (Page 45)

43
Menu System
GB
C)
Normally the automatic fine tuning (AFT) option will give the best
possible picture, however you can manually fine-tune the TV to
obtain a better picture if the picture is distorted.
To do this:
1 Press PROG +/– to select the programme number with the channel
you want to fine-tune manually.
You cannot select the programme number set to skip in the
“Skip” option (see step D on page 43).
2 When the programme you want to fine-tune appears on the screen,
select the AFT option and press
.
3 Press or to adjust the fine tuning between –15 and +15 and
press OK.
4 Highlight the Confirm option and press OK. Then press to select
OK and finally press OK to store your choice.
To restore automatic fine tuning, select On in step 3 above.
D)
Skip any unwanted programme numbers when they are selected with
the PROG +/– buttons.
To do this:
1 Highlight the Programme option and press . Then press or
to select the programme number you want to skip.
2 When the programme you want to skip appears on the screen, select
the Skip option and press
.
3 Press or to select Yes and press OK.
4 Highlight the Confirm option and press OK. Then press to select
OK and finally press OK to store your choice.
To cancel this function afterwards, select No instead of Yes in step 3
above.
E)
View and record scrambled channels when using a decoder connected
to the Scart connector
1/ either directly or via a VCR.
Depending on the country/region you have selected in the
“Country” option, this option may not be available (see
page 40).
To do this:
1 Press PROG +/– to select the programme number with the scrambled
channel you want to view.
You cannot select the programme number set to skip in the
“Skip” option (see step D on page 43).
2 When the programme you want to view appears on the screen, select
the Decoder option and press
.
3 Press or to select On and press OK.
4 Highlight the Confirm option and press OK. Then press to select
OK and finally press OK to store your choice.
To cancel this function afterwards, select Off instead of On in step 3
above.