Sony CDX-505RF - Manual (Page 6)

6
EN
CD Changer
Listening to a CD
1
Turn on the FM tuner of the car audio.
2
Adjust the selected transmitting
frequency with the wired remote.
(88.3 MHz/88.5 MHz/88.7 MHz/88.9 MHz/
89.1 MHz/89.3 MHz/89.5 MHz/89.7 MHz/
89.9 MHz)
3
Press ^.
CD playback starts.
When the unit is used in a car without an
accessory position on the ignition switch
Be sure to press (OFF) on the wireless remote to turn the
system off to avoid battery wear while the engine is not
running.
If the POWER SELECT switch on the hideaway unit is set
to the OFF position and the display on the wired remote is
turned off, you will not be able to start CD playback with
the wireless remote. In this case, press
^ on the wired
remote .
4
Adjust the volume with the volume
control on the car audio.
All the tracks play from the beginning.
Locating a specific track
— Automatic Music Sensor (AMS)
During playback, press either side of
(AMS) once for each track you wish to
skip.
Locating a specific point in a track
— Manual Search
During playback, press and hold
(DISC+)or (DISC–). Release the button
when you have found the desired part.
AMS
To locate
succeeding tracks To locate
previous tracks
To search forward
To search backward
DISC
DISC
Mounting the wireless remote
Use the supplied velcro tapes and mount the
wireless remote to a suitable location where it
will not interfere with your driving.
Changing the transmitting
frequency
Because this unit processes CD playback
sound through an FM tuner, there may be
interference noise during CD playback. In this
case change the frequency of the modulated
RF signal transmitted from hideaway unit. The
initial setting is 88.3 MHz.
1
Press (REP) for two seconds.
2
Press either the left or right side of
(AMS) to select the frequency.
Each time you press (AMS), the frequency
changes as follows:
=: 88.3 MHz n 89.9 MHz n 89.7 MHz n
89.5 MHz n 89.3 MHz n 89.1 MHz n
88.9 MHz n 88.7 MHz n 88.5 MHz n
88.3 MHz
+: 88.3 MHz n 88.5 MHz n 88.7 MHz n
88.9 MHz n 89.1 MHz n 89.3 MHz n
89.5 MHz n 89.7 MHz n 89.9 MHz n
88.3 MHz
3
Press (REP) for two seconds.
Note
Be sure to set the frequency of your FM tuner to that of the
newly selected frequency.
to the mounting
surface Velcro tapes