Sima Products Sima SUR-47 - Manual (Page 21)

SUR-47 User’s Manual Specifications
17
Debugging Device Codes
Use this procedure if the SUR-47 is unable to recognize the infrared signals from another remote control.
Once you have collected unrecognizable codes, you can use the optional SUR-PC link cable (see
Appendix B - Accessories on page 34 for more info) to upload them to your personal computer and then email
them to Sima Products for analysis.
The email address is [email protected]
Every time you enter DEBUG mode, the SUR-47 replaces previously stored
unrecognized codes with new ones. If you have more than one remote that is not
programmable, upload the first remote’s unrecognized codes and then gather the
second remote's unrecognized codes.
Set up the LCD display before using this function. See LCD Layout on page 18.
1. Press or to select DEBUG .
2. Press .
3.
Point the target device's remote
control at the SUR-47 learning eye
located at the bottom of the unit
(see Figure 1A: SUR-47 Front View).
4. Select a device (for example TV).
The SUR-47 Touch Screen sequentially displays screens corresponding to first the hard
keys, then page one of the soft keys, and finally page two of the soft keys. The blinking
rectangle denotes the key being learned.
5. Press the corresponding button of
the target device's remote control.
The SUR-47 screen displays an OK
message if the code was
successfully learned.
Press PAGE to toggle between
hard key and soft key displays.
6. Press YES or EXIT to exit debug
mode.