Sony RM-VLZ620 - Manual (Page 12)

12
RM-VLZ620_U (US) 4-170-639-12(1)
To check which Device Select
button is set for a Sony
device
Press POWER in Step 3 above.
The Device Select buttons set for
Sony devices will flash in sequence.
Device Select buttons set for non-
Sony devices will not flash.
To set automatic power-on
control again
Perform the same procedure as
when you clear the automatic
power-on control.
Notes
 If you set the manufacturer’s code of a
non-Sony device on a Device Select
button, you cannot set the automatic
power-on control on the button.
If you change to the code of a non-Sony
device after setting automatic power-on
control, the control will be cleared.
 If you attempt automatic power-on control
for a non-Sony device, the SET indicator
will flash once and turn off (to indicate
that you cannot set this control).
 If you teach a signal or program a
consecutive procedure to a Device Select
button to which the automatic power-on
control is set, the control will not work. To
activate the control, clear the learned
signal or programmed consecutive
procedure from the Device Select button.
Setting the
Manufacturer’s Code
for Non-Sony Devices
You can use the RM-VLZ620 for major
brand A/V devices. To use with non-
Sony A/V devices, or Sony devices that
are not preset at the factory (see table
below for factory setting), you need to
set the manufacturer’s code for each
device to any of the eight Device Select
buttons.
Device
Select
button
Preset
device
Factory
setting*
TV Sony TV 02473
CBL (SAT) Cable set top box
(non-Sony)
51376
DVR (PVR) Sony digital video
recorder
22676
DVD Sony DVD player 11033
BD Sony Blu-ray Disc
player
11516
VCR Sony VCR 60032
CD Sony CD player 70000
AMP Sony receiver 82586
* The five-digit code is the preset
manufacturer’s code.
Notes
 Only a TV or projector can be assigned to
the TV Device Select button. You can
assign any device to the other Device
Select buttons. For button functions for
each device, see “Table of Preset Functions”
(page 36).
 If no operations are performed for 10
seconds while setting, the setting will be
canceled, and must be restarted.
 Some devices that do not support infrared
signals will not work with the
RM-VLZ620.