Sony RM-VLZ620 - Manual (Page 22)

22
RM-VLZ620_U (US) 4-170-639-12(1)
Note
If the SET indicator flashes only once, it
indicates that learning is incomplete.
Repeat from Step 4 again.
7
Repeat Steps 4 to 6 to teach
other new functions.
8
Press SET to finish teaching.
The SET indicator turns off.
To cancel the process
Press SET anytime.
Notes
 If you teach a signal to a button, the
learned function will remain even after
you set a manufacturer’s code.
 You cannot teach a simultaneous button
operation (for example  + ) to the
two buttons on the RM-VLZ620 at a time.
In this case, teach the signal to a single
button while pressing two buttons on the
original remote control at the same time.
To teach an air-conditioner’s
functions
If you adjust the setting of the air-
conditioner according to the season,
reset the parameters of the air
conditioner’s remote control
(temperature, air strength and
direction, etc.), and teach the new
remote signals to the RM-VLZ620.
When the power button on the
remote control for an air-
conditioner, etc., toggles between
power-on and off with each press,
the power-on/off operation may not
be learned correctly. In this case,
teach the power-on/off signals to
two separate buttons on the
RM-VLZ620.
1 Teach the power-on signal to a
button (transmit the power-on
signal by pressing the power
button when the device is turned
off).
2 Teach the power-off signal to
another button (transmit the
power-off signal by pressing the
power button when the device is
turned on).
The two learned buttons of the RM-
VLZ620 now control the power-on/
off signals of the device respectively.
Note
Devices such as air conditioners and heaters
receiving an infrared signal can be dangerous
if misoperated. Be sure to place the RM-
VLZ620 out of the reach of small children or
pets, and lock the controls using the Hold
function (page 31).
Tips for teaching accurately
 Do not move the remote control
units during the learning
procedure.
 Use new batteries in both remote
control units.
 Avoid performing the learning
procedure in places subject to
direct sunlight, or strong
fluorescent light. (Noise may
interfere with the learning
procedure.)
 The remote control detector area
may differ depending on each
remote control unit. If the RM-
VLZ620 does not learn signals, try
changing the positions of the two
remote control units.
 When you teach the signals of an
interactive signal exchange system
remote control unit (supplied with
certain Sony’s amplifiers) to the
RM-VLZ620, the response signal
of the main unit may interfere
with the learning of the RM-
VLZ620. In such a case, move to a
place where the signals will not
reach the main unit (e.g., another
room).