Sony RM-VLZ620 - Manual (Page 21)

21
Con
tr
olling De
vic
es
RM-VLZ620_U (US) 4-170-639-12(1)
2
Press and hold SET for more
than 3 seconds.
While keeping SET held
down, press , then release
both buttons.
The SET indicator
lights up.
3
Enter  - 8 - 8.
The SET indicator flashes three
times to indicate that the setting
mode has been entered.
3 flashes
4
Press the Device Select
button for the device you
want to control.
The selected Device Select button
lights up.
5
Press the button on the RM-
VLZ620 you want to teach.
The SET indicator flashes with
the button press. (Learning
function standby.)
flash
Note
Perform the next step within 30 seconds.
Otherwise, the SET indicator flashes
once and the learning procedure returns
to Step 4.
6
Press the button on the
original remote control to
transmit the signal to the
RM-VLZ620.
During signal transfer, only the
SET indicator stays lit, and the
Device Select button turns off.
After signal transfer is complete,
the SET indicator flashes three
times, and the RM-VLZ620
returns to the state in Step 4.
Data transfer
completed
Remote
control of
device
3 flashes