Sennheiser Tourguide Wireless Transmitter SR 2020 D - Manual (Page 11)

9
Putting the SR 2020 D into operation
Putting the SR 2020 D into operation
Preparing the transmitter for use
You can set up the SR 2020 D transmitter on an even surface or
mount it into a 19“ rack.
Note:
Do not fit the rubber feet when rack mounting the trans-
mitter.
Setting up the transmitter on an even surface
To ensure that the transmitter cannot slip on the surface on
which it is placed, four self-adhesive soft rubber feet are
supplied.
̈
Ensure that the base of the transmitter is clean and free from
grease before mounting the rubber feet.
̈
Fix the rubber feet to the base of the transmitter by peeling
of the safety paper and fitting them as shown in the diagram
on the left.
Connecting the antenna
̈
Connect the telescopic antenna to the antenna output
¹
at
the rear of the transmitter.
To obtain the best possible radiation power:
̈
Align the antenna vertically.
Risk of staining of furniture surfaces!
Some furniture surfaces have been treated with
varnish, polish or synthetics which might cause
stains when they come into contact with other
synthetics. Despite a thorough testing of the
synthetics used by us, we cannot rule out the
possibility of staining.
̈
Do not place the transmitter on delicate
surfaces.
CAUTION!
¹