Sharp DT-200 - Manual (Page 25)

E-24
Operation Buttons
Selecting the Input Signal Source
Using the Operation Buttons
Press INPUT on the projector, INPUT 1, INPUT 2, INPUT
3, INPUT 4 or DIGITAL INPUT on the remote control to
select the desired input mode.
• When no signal is received, “NO SIGNAL” will be displayed.
When a signal that the projector is not preset to receive is
received, “NOT REG.” will be displayed.
On-screen Display
Adjusting the Picture Aspect Ratio
This function allows you to modify or customize the
picture display mode to enhance the input image.
Depending on the input signal, you can choose
NORMAL, BORDER or STRETCH image.
1 Press RESIZE. Each time RESIZE is pressed, the
picture mode changes as shown on the next page.
1
INPUT button INPUT 1 Mode
DIGITAL Mode INPUT 4 Mode
INPUT 2 Mode INPUT 3 Mode
DT-200(E)#p24_25.p65 02.11.21, 11:40 AM 24