Sharp DT-200 - Manual (Page 35)

E-34
Basic Operation
Adjusting the Computer and DVD/DTV Images
Special Modes Adjustment
Ordinarily, the type of input signal is detected and the
correct resolution mode is automatically selected.
However, for some signals, the optimal resolution mode
in “Special Modes” on the “Fine Sync” menu screen
may need to be selected to match the computer display
mode.
1 Press MENU. The “Picture” menu screen appears.
2 Press / to display the “Fine Sync” menu
screen.
3 Press / to select “Special Modes”, and then
press .
4 Press / to select the optimal resolution.
5 Press ENTER to save the setting.
6 To exit the menu screen, press MENU.
• Avoid displaying computer patterns which repeat every other line
(horizontal stripes). (Flickering may occur, making the image hard
to see.)
• When inputting DTV 1080i signal, select the corresponding type of
signal in step 4 above.
• When inputting 720P RGB signal, select the corresponding type
of signal in step 4 above.
• “Special modes” cannot be used in the DIGITAL INPUT mode.
On-screen Display
On-screen Display
Checking the Input Signal
This function allows you to check the current input signal
information.
1 Press MENU. The “Picture” menu screen appears.
2 Press / to display the “Fine Sync” menu
screen.
3 Press / to select “Signal Info” to display the
current input signal.
4 To exit the menu screen, press MENU.
2,3,4
1, 6
5
2,3
1, 4
DT-200(E)#p34_35.p65 02.11.21, 11:43 AM 34