Sharp DT-200 - Manual (Page 33)

E-32
Basic Operation
Picture Setting Function
This function stores all items set in “Picture”. Five
settings can be stored separately in “Memory 1” to
“Memory 5”. Each stored setting is reassigned to each
input mode (INPUT 1 to INPUT 4 and DIGITAL).
Even when the input mode or signal is changed, you
can easily select optimal settings from the stored
settings.
• This function can be operated using the PICTURE SETTING
button on the projector or on the remote control, as well as
the OSD menu screen.
Description of Picture Setting
Memory 1-5 Settings of all items in “Picture” can be stored for
the respective input modes. The stored settings
can be selected in any input modes.
Memory Besides “Memory 1” to “Memory 5”, other settings
OFF can be stored for each input mode. “Memory OFF”
can be selected for each input mode.
Selecting “Memory 1-5” or “Memory
OFF” Using the PICTURE SETTING
Button
1 Press PICTURE SETTING, Each time PICTURE
SETTING is pressed, the memory number
changes as shown below.
Memory 1 Memory 2 Memory 3
Memory OFF Memory 5 Memory 4
Storing the Adjustment Values for
each Memory Number
1 Press MENU. The “Picture” menu screen
appears.
2 Press / to select “Picture Setting”, and then
press .
3 Press / to select the desired memory number
for the picture settings.
4 Press ENTER to save the settings. Adjust the
settings described on pages 29 to 31. The values
that are adjusted are stored.
5 To exit the menu screen, press MENU.
On-screen Display
1
Selected item Description
Adjusting the Picture
2, 3 4 1, 5
DT-200(E)#p26_32.p65 02.11.21, 11:38 AM 32