SATO M10e - Manual (Page 41)

Section 3. Configuration
SATO M10e PN 9001101 Rev. A Page 3-19
CARD->MEMORY
COPY COPYING 3. Press the ENTER key to accept the selection. If Yes was
selected the copy process will start
CARD->MEMORYCOPY
COMPLETED
4. Once the copy process is completed, press the ENTER key
to step the display.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error
Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
MEMORY->CARDCOPY
PROGRAM Y/N
This selection allows the user to copy the current firmware
installed in the printer to a PCMCIA Memory Card.
1. Use the Cursor keys to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode. If
No is selected, the display will advance to the mode display.
COPY START
YES NO
2. Press the ENTER key to accept the selection. If Yes was
selected the copy process will start. If you select No, the
display will return to the previous selection.
MEMORY->CARDCOPY
COMPLETED
3. Once the copy process is completed, press the ENTER key
to step the display.
CARD COPY/FORMAT
XXXXXXX ERROR
4. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error
Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
CARD FORMAT
YES NO
Before a PCMCIA card can be used, it must be formatted.
Note: Formatting a card destroys all data currently stored
on the card.
1. Use the Cursor keys to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Format mode.
If No is selected, the display will advance to the mode
display.
MEMORY FORMAT
YES NO Before the internal Expanded Memory can be used, it must be
formatted.
Note: Formatting the Memory will destroy any stored data.
1. Use the Cursor keys to step the cursor to desired setting. If
Yes is selected, the printer will enter the Memory Format
mode. If No is selected, the display will advance to the mode
display.