SATO M10e - Manual (Page 48)

Section 3. Configuration
Page 3-26 PN 9001101 Rev. A SATO M10e
DEFAULT SETTING MODE
Occassionally it is desirable to reset all printer configuration settings to their original default
conditions. This allows the operator to start reconfiguration of the printer starting from a know
set of conditions.
TEST PRINT MODE
CONFIGURATION This option allows you to print a test label. It is recommended
that you print a test label after you have changed any of the
settings in the Advanced Mode. The test label allows you to
verify that you indeed did make the desired changes. To enter
the Test Print Mode, power the printer on while pressing the
FEED key. The printer will beep. Release the FEED key and the
printer will display the following message on the LCD panel:
1. Use the Cursor keys to step the cursor to type of test label
you wish to print. The choices are:
CONFIGURATION
BARCODE
HEADCHECK
MEMORY
FACTORY
TEST PRINT SIZE
10 CM
Note: This screen will not be displayed for the Memory
Test Label.
Once you have selected the type of test label to be printed, use
the ENTER key to accept the selection and the display
advances to the Test Print Size display. This display allows you
to select the label width.
1. Use the LINE key to select the lable width. Each time the
LINE key is pressed, the label size advances 1 cm until it
reaches a maximum width of 26 cm, at which point it will
wrap to the smallest size of 13 cm.
PRESS FEED KEY TO
STOP PRINTING 2. Pressing the ENTER key accepts the selection.
3. Press the FEED key to start printing test labels continuously.
4. Press the FEED key to stop the printer.
5. To exit the Test Print Mode, power the printer off and then
back on.
V 05.00.03.00
INITIALIZING
Displays the firmware during the initialization.
DEFAULT SETTING
YES NO
You enter the Default Setting Mode by pressing the LINE and
FEED keys while simultaneously powering the printer on. The
printer will emit one long beep after which the FEED and LINE
keys should be released.
1. Use Cursor keys to select either the YES or NO.
2. Once the desired setting is selected, pressing the ENTER
key will accept the selection and the printer will reset to the
original default conditions.