About the indicators on the display – Sony 3-289-450-44(1) User Manual
Page 8
8
GB
About the indicators on the display
1
2
3 4
5
6
7
8
9
0
qa
qj
qd
ws
wa
w;
ql
qk
qh
qf
qg
qs
Name
Function
A SW
Lights up when the audio signal
is output from the
SUBWOOFER jacks.
B LFE
Lights up when the disc being
played back contains an LFE
(Low Frequency Effect)
channel and the LFE channel
signal is actually being
reproduced.
C COAX
Lights up when INPUT MODE
is set to “AUTO” and the source
signal is a digital signal being
input through the COAXIAL
jack (page 75).
D OPT
Lights up when INPUT MODE
is set to “AUTO” and the source
signal is a digital signal being
input through the OPTICAL
jack (page 75).
E ; D/
; D EX/
; D+/
; TrueHD
“; D” lights up when the
receiver is decoding Dolby
Digital signals.
“; D EX” lights up when the
receiver is decoding Dolby
Digital Surround EX signals.
“; D+” lights up when the
receiver is decoding Dolby
Digital Plus signals.
“; TrueHD” lights up when
the receiver is decoding Dolby
TrueHD signals.
Note
When playing a Dolby Digital
format disc, be sure that you
have made digital connections
and that INPUT MODE is set to
“AUTO” (page 75).
Name
Function
F Neural - THX Lights up when the receiver
applies Neural - THX
processing to input signals.
G DTS/
DTS-ES/
DTS 96/24
“DTS” lights up when the
receiver is decoding DTS
signals.
“DTS-ES” lights up when the
receiver is decoding DTS-ES
signals.
“DTS 96/24” lights up when the
receiver is decoding DTS
96 kHz/24 bit signals.
Note
When playing a DTS format
disc, be sure that you have made
digital connections and that
INPUT MODE is set to
“AUTO” (page 75).
H D.RANGE
Lights up when dynamic range
compression is activated (page
48).
I SP A/SP B/
SP A+B
Lights up according to the
speaker system used (page 30).
However, these indicators do
not light up if the speaker output
is turned off or if headphones
are connected.
J SLEEP
Lights up when the sleep timer
is activated (page 81).
K Tuner
indicators
Lights up when using the
receiver to tune in radio stations
(page 63), etc.
Note
“RDS” appears for models of
area code CEL, CEK, ECE
only.