SMC Networks SMC EZ 10/100/1000 SMCGS8P-Smart - Manual (Page 326)

C
OMMAND
L
INE
I
NTERFACE
3-158
ip igmp snooping vlan mrouter
Use this command to statically configure a multicast router port.
Use the no form to remove the configuration.
Syntax
ip igmp snooping vlan vlan-id mrouter interface
no ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4094)
• interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may
not always be able to locate the IGMP querier. Therefore, if the
IGMP querier is a known multicast router/switch connected
over the network to an interface (port or trunk) on your switch,
you can manually configure that interface to join all the current
multicast groups.
Example
The following shows how to configure port 11 as a multicast
router port within VLAN 1:
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/11
Console(config)#
b_mgmt.book Page 158 Tuesday, July 8, 2003 5:24 PM