Sun Microsystems X6450 - Manual (Page 33)

Chapter 2 Installing and Configuring the Server Module 23
Service Processor Versions
Your server module might be equipped with one of several versions of the SP:
■ ILOM 3.0 – This is the newest version of the service processor software. It is
described in this section.
For additional documentation, see the ILOM 3.0 documentation collection.
■ ILOM 2.0 – This version of the service processor software is also described in this
section.
For additional documentation, see the ILOM 2.0 documentation collection.
■ ELOM – Older systems might be equipped with an ELOM.
For additional documentation, see the ELOM documentation collection.
While there are fundamental differences between ILOM 2.0 and ILOM 3.0, they do
not affect the procedures in this section; all of these procedures can be used for both.
Any minor differences are noted where they occur.
The ILOM provides both a command line interface (CLI), and a web interface. This
section provides procedures for using both of these interfaces.
Upgrading or Migrating the Service Processor
You can migrate your SP from ELOM to ILOM 2.0, and you can upgrade ILOM 2.0 to
ILOM 3.0.
ELOM to ILOM 2.0
■ See the ELOM-to-ILOM Migration User’s Guide.
ELOM to ILOM 3.0
■ Migrate to ILOM 2.0 as described in the ELOM-to-ILOM Migration User’s Guide.
■ Upgrade to ILOM 3.0 as described in the Sun Integrated Lights Out Manager 3.0
Supplement for Sun Blade X6450 Server Module.
Caution – When you migrate from ELOM to ILOM 2.0, use SW2.0.3 or newer. Do
not migrate from ELOM to a version of ILOM from an earlier software release.
Displaying the Service Processor’s IP Address
Use the following procedure to display the ILOM’s network configuration, including
the IP address of the ILOM SP, using the CMM ILOM.